How To Design The Position Of Buttons And Buttonholes?

Jul 13, 2022

In the changing style of clothing, various buttons can be used. The designer must refer to the front center line position as far as possible, and preferably the waist button position according to the style.

The most important thing is to buckle the eyes. It shall be marked on the horizontal line where the base point of the barge line is located (the barge line passes through point x).

The waist button is also very important. It is often located above or below the waist line. In the connection type jacket, there is only one button (connection type double button), which is always located 2cm above the waist line to prevent the butt from arching. The current style mostly uses the middle button or the lowest button, while in the traditional style, the narrow LAPEL SUIT often uses the high button position. Two buttons are more convenient. The distance between buttonholes depends on the style. Generally, the distance between buttonholes is at least 6cm (sometimes less) and at most 1.5cm (generally 9-10cm).

In the single row button style, the distance between the button and the buttonhole to the corresponding edge is theoretically equal or basically equal. This is especially suitable for the style with narrow placket (2-3cm), because here, the button means to be on the front midline. In fact, the buttonhole of a suit is usually very close to the seam line, about 1 ~ 2cm. The buttons are often sewn on the inner side of the seam edge (preferably in the folded door), and sometimes move inward or outward to adjust the tightness of the garment. In this way, we do not have to move the distance of the front midline (such as the high button suit coat).

In the double row button style, the distance between the double row buttons and the front center line is mainly determined by the width of the placket. This style usually has a wide lapel, with the button below or above the waist line. The distance between the double row buttons and the front midline is close, usually 6 ~ 8cm (the button spacing is 10 ~ 11cm); For the traditional style with low butt and low button position, the distance is usually 9cm or even 10cm (while the button spacing is 14-15cm).

When designing the buttons and buttonholes of the double breasted suit jacket, the buttonholes on the placket are usually marked 1 ~ 2cm away from the seam edge. Then, for the convenience of sewing, the distance from the front center line is measured on the opposite side to determine the second button position line (of course, there is no buttonhole on this line). On the bottom flap, the single row of buttonholes are usually closer to the seam than the buttons measured inside, so as to keep the seam edge of the lower folding door in a proper position.