Button inspection methods, requirements and standards
Jul 01, 2022
I believe everyone is familiar with buttons, because the clothes we usually wear have buttons, and the buttons now are not the same as those in the past. In the past, the buttons were all made by hand, but now the buttons we use are all made by tools. The clothes we usually wear do not only have one or two buttons, but also have seven or eight buttons. But we need so many buttons for every clothes, We can't supply it manually, so many manufacturers now choose full-automatic button machines to order buttons. We will briefly introduce the methods, requirements and standards of button inspection to you:
1. Control sample or confirmation sample. Check whether the color and model are consistent with the sample;
2. The button surface shall be free of cracks, notches, irregularities and obvious scratches;
3. The back of the plastic button face shall be free of cracks and bubbles; No rotten edges and uneven thickness;
4. The pattern shall be free of obvious deformation, white eyes, white circles, etc;
5. Buttonholes shall be smooth and smooth; The needle eye shall be symmetrical and free of big eyes. In case of concealed eye buckle, the concealed eye groove shall be smooth without obvious bursting.
6. After electroplating or other process treatment, the effect should be uniform. If some special effects cannot be consistent, they can be packaged separately.
7. The color difference of buttons in the same batch shall not be lower than grade IV standard of gb250, and shall not be lower than grade III standard of gb250 compared with the incoming samples.
8. Packaging inspection: after the appearance inspection / performance test required by the customer are all qualified, sub packaging can be carried out. The certificate of conformity or other labels shall be put in the packaging. The quantity of packages shall be consistent with the specified quantity, and the actual quantity of each bag shall be consistent with the specified quantity. If it is found that the thickness is different or other reasons exceed the tolerance, all the packages shall be inspected.
9. The emergency button / Hood button / five claw button shall be tested before delivery to test the button performance and usability. The full-automatic button machine shall be used and the moulds and trial samples shall be provided to the customer.







